In Stock

Cnoga MTX- Non-Invasive Blood Bio-Parameters Measurements

₨ 255,000

16 Bio-parameters in 60 seconds

How does it work

  • Four LED lights shine wavelengths from visual light to infrared light through the fingertip.
  • As the light wave pass through the fingertip, some of it is absorbed and the light signal is changed.
  • Next, a camera sensor detects the changed light signal in real time.
  • Using patented algorithms and a vast amount of data
    MTX analyze the correlation between the signal and bio parameters

Unique technology

  • Continuous, Non-invasive and Cuff-free Blood Pressure
  • Non-invasive Hemoglobin, Hematocrit, and RBC
  • Non-invasive Blood Gases (Ph, PCO2, PO2, O2&CO2 Content)
  • Non invasive Cardiac Output , Stroke Volume, MAP

Parts Included

TensorTip is supplied with the following components:

  • MTX device
  • Battery charger
    • Input: 100v~-240v~, 50Hz – 60Hz
    • DC Output: 5v / 1300mA
  • Stand/Finger Chamber cover
  • Protective pouch
  • Self-Test Arc
  • User Manual

 

Add to wishlist
Compare
SKU: CNOGAMEDIT_PK Category:

Description

Product Description

Cnoga MTX- Non-Invasive Blood Bio-Parameters Measurements

 

Hemodynamics

  • Pulse
  • Continuous Blood Pressure
  • Cardiac Output
  • Stroke Volume
  • Mean Arterial Pressure
  • OCG – Optical cardiogram

 

Hematology

  • Hemoglobin
  • Hematocrit
  • Red Blood Count
  • Blood Viscosity

 

Blood Gases

  • Oxygen Saturation (SpO2)
  • PCO2
  • PO2
  • O2 Content
  • CO2 Content
  • PH

 

Instructions For Disinfection

1. Washing your hands:
Before using the device, wash hands thoroughly with warm water to prevent contamination and infections.
Dry your hands completely with the use of a clean towel.

2. Disinfection of hands:
Apply 70% alcohol hand sanitizer and wait for alcohol to air dry.

3. Disinfecting the device before measuring:
I. Open the lid of the fingertip compartment.
II. Clean the finger compartment well with a 70% Isopropyl alcohol wipe (make sure that the pad is moist, not soaked (to prevent the alcohol from permeability into the device).
Do not to touch the gel with alcohol, only the plastic part.
III. Wait for the alcohol to air dry.
iv. Close the finger compartment.

4. After the measurement:
Wipe with 70% Isopropyl alcohol moist wipes (pads) the whole device (inside and outside) to prevent infections.
Do not to touch the gel with alcohol, only the plastic part.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Related products